Siemens SIPART PS2 Operating Instructions Manual page 39

This section describes how to connect the positioner to the actuator using the mounting kit
6DR4004-8V. You require different installation parts of this mounting kit depending on the
selected actuator type. All installation parts listed in the following table are included in the
product package of the mounting kit 6DR4004-8V. The mounting kit is suitable for a stroke of
3 to 35 mm. In the event of a larger range of stroke, you require the accessory "Lever for
strokes greater than 35 to 130 mm", article number 6DR4004-8L, in addition to the mounting
set 6DR4004-8V. Keep the suitable installation parts ready:
Actuator type
Yoke with fin
Yoke with
plane surface
Yoke with
columns
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
Required installation compo-
nents
⑧
Hexagon bolt
•
⑪
Washer
•
⑩
Spring lock washer
•
⑧
Four hexagon bolts
•
⑪
Washer
•
⑩
Spring lock washer
•
⑦
Two U–bolts
•
⑳
Four hexagon nuts
•
⑪
Washer
•
⑩
Spring lock washer
•
Installing/mounting
4.2 Mounting the linear actuator
39