Drive Motor Replacement; About; Procedure - Precor GEN06 Series C952 Service Manual

Drive Motor Replacement

About

This procedure provides instruction to remove and replace the Drive Motor.

Procedure

Review entire procedure before starting.
1. Switch the input power OFF and unplug the power cord.
2. Remove the front hood.
3. Disconnect the drive motor power cable connector from the OUTPUT connector on the
power control module.
TIP: Remove the MC fasteners so that the MC module can be raised to allow easy
access to disconnect and connect the I/O connectors.
4. Remove the drive belt. It is recommended that you walk the belt off the smaller drive
motor pulley.
5. Mark the outline of the current motor mounting plate which will be used as a reference
position when you install the replacement motor.
6. Remove the four drive motor mounting bolts. Keep bolts for replacement installation.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
5 Replacement Procedures
Drive Motor Replacement
40