Precor GEN06 Series C952 Service Manual page 44

12. Adjust the right drive roller mounting bolt so that the right drive roller shaft to frame cross
beam distance equals the left side reference distance. This adjustment will make sure
that the drive roller is positioned parallel and square to the front of the frame.
13. Install the drive belt onto the drive motor pulley and walk the drive belt onto the larger
drive roller pulley.
14. Verify the drive belt alignment and set tension to specification, see
Alignment Adjustment" on page 21
15. Set the running belt tension to specification and verify tracking, see
(Undefined variable: TRM700-16Base.ServiceManualTitle)
procedure.
5 Replacement Procedures
Drive Belt Replacement
"Drive Belt Tension &
"Running Belt
38