Running Belt And Deck Cleaning Procedure - Precor GEN06 Series C952 Service Manual

Quarterly Task
Verify the running belt tension,
alignment, and tracking.
Verify the drive motor belt tension. Verify the drive motor belt tension and adjust as neces-
Vacuum the front compartment
and motor controller fan.
Check the console metric and
indicator display and numeric
keypad functionality.
Record the current Odometer and
Hours.
Note: 1). Perform task with power removed and incline set to maximum level.
2) Diagnostic Test will vary depending on console model.
Semi-Annually
Perform the following maintenance tasks every 6 months:
Semiannual Task
Clean and lubricate the Lift Motor jack
screw.

Running Belt and Deck Cleaning Procedure

Review the entire procedure before beginning.
1. First, check for proper operation of the safety Stop key.
a. Stand to one side of the treadmill – Do not stand or allow others to stand on the
treadmill running belt during this procedure. Ensure that the stop key tether is
hanging straight down and is not wrapped around the handle bars.
b. Select Quick Start and wait for the running belt to begin moving
(Undefined variable: TRM700-16Base.ServiceManualTitle)
Running Belt and Deck Cleaning Procedure
Verify the running belt tension, alignment and tracking,
see "Running Belt Adjustment" procedure.
sary, see "Drive Motor Belt Tension Adjustment" pro-
cedure.
Remove hood and vacuum the compartment and motor
controller fan. It is recommended that you use a static
resistant vacuum cleaner. Be careful to not put nozzle
near PCA electronics.
Run the Display\Keypad diagnostic tests and check the
console metric/indicator LED/LCD displays and numeric
keypad functionality. On P80 series touch-screen con-
soles, run the Touchscreen/Backlight/RGB/Numeric
Backlight/Numeric Display diagnostic tests, refer to
"Hardware Validation - Diagnostic Tests (51765761)"
on page 13.
Access the Information Display or Equipment Usage
data and record the Odometer and Hours metrics, see,
"Information Display (65)" on page 18
Raise the Incline to maximum, Switch the input
power OFF, and disconnect the power cord.
Clean the jack screw and apply approved grease,
see "General Information" on
7 Preventative Maintenance
Instruction
Instruction
page 3.
99