Precor GEN06 Series C952 Service Manual page 68

10. Slide the running belt off the deck and discard. Remove and keep the deck mounting
inserts.
11. If the deck has already been flipped (flipped surface is used), discard and replace with
new deck. Re-install the deck mounting inserts.
12. If the deck has not be flipped (flipped surface is new), flip deck and re-install the deck
mounting inserts into the used side of the deck surface.
13. The new running belt will have a directional arrow placed on the inside of the belt. The
arrow indicates the correct direction of travel. Slip the running belt onto the deck with the
arrow pointing in the direction of travel.
CAUTION: Incorrectly installed running belt direction will cause the belt to wear pre-
maturely.
14. Carefully place the deck with running belt onto the deck.
15. Reinstall the Auto Stop Magnet on the right front corner of the deck, see
Magnet Replacement" on
16. Slide the take up roller though the running belt and install in the frame mounting bracket.
Hand tighten the mounting bolts into the take up roller shaft.
17. Align the bottom plate and pivot bracket holes with the running deck bolt holes. Replace
the roller guard, install and hand tighten the deck mounting bolts.
18. Verify that the spacing on all four corners is the same, adjust as necessary.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
page 30.
5 Replacement Procedures
Running Belt and Deck Replacement
"Auto Stop
62