Precor GEN06 Series C952 Service Manual page 64

5 Replacement Procedures
Power Control Module Replacement
6. Install and tighten the four mounting screws.
7. Reconnect the COMM, INCLINE, INPUT, DB and OUTPUT connectors. The mating
connectors are keyed to insure proper contact pin alignment and fit.
8. Reinstall the hood.
9. Pug in the power cord and Switch the input power ON.
10. Verify treadmill operation (see Operation Verification) and return to service.
See Also
"Replacement Procedures" on page 29
(Undefined variable: TRM700-16Base.ServiceManualTitle) 58