Precor GEN06 Series C952 Service Manual page 103

Daily Task
Clean the running belt top surface.
Clean the running belt and deck.
Check for the following possible
issues:
Slipping belts
l
Loose fasteners
l
Unusual noises
l
Worn or frayed power cords
l
Worn, damaged, missing
l
safety lanyards or clips
Visually inspect the running belt con-
dition and alignment/tracking.
Weekly
Perform the following maintenance tasks every week:
Weekly Task
Verify unit sits level and solid on floor.
Perform the following items at maximum
Incline, power switch OFF, and cord dis-
connected:
Verify that the power cord is not
l
damaged or laying underneath the
1
treadmill .
Vacuum and clean area under-
l
neath equipment
Clean surfaces on foot contact loc-
l
1
ations .
Connect power cord and Switch the input
power ON, set incline to 0%.
Verify the treadmill operation and func-
tionality.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
water.
Clean the top surface of the running belt with a soft
dry or damp cloth using an
Clean the running belt and deck, see
and Deck Cleaning Procedure" on
Verify that none of the following issues are occurring:
l
l
l
l
l
Make sure that the running belt is not frayed/worn
and that the belt alignment and tracking is centered
on the deck and rollers.
Use bubble level placed on running belt to verify
level. All feet should be touching the floor and
the unit should not rock or wobble when in use.
Raise Incline to maximum level, then Switch the
input power (circuit breaker) to OFF and unplug
the power cord.
Verify that the power cord is not damaged,
pinched, coiled, or positioned under the tread-
mill.
Vacuum and/or use damp mop to clean floor
1
. area underneath equipment. Make sure the floor
is completely dry.
Use a soft nylon scrub brush to clean the
grooves and textured surfaces on foot contact
locations.
Plug-in the power cord and switch unit power
ON. The incline level will automatically reset to
the 0% "Home" position.
Perform the
on page 8
Instruction
approved
Slipping belts
Loose fasteners
Unusual noises
Worn or frayed power cords
Worn, damaged, missing safety lanyards or
clips
Instruction
"Operation Verification Procedure"
to verify unit features and functions
7 Preventative Maintenance
Maintenance Schedule
cleaner.
"Running Belt
page 99,
97