F5 Do-02 Set-Up - YASKAWA VS-616G5 Series Programming Manual

F5 DO-02 Set-up
The DO-02C option card has 2 form C type dry contacts. Each of the dry contacts can be individually
set by F5-01 and F5-02.
The DO-02C option card connects to the control board at 3CN.
The table is a list of items that can be selected.
F5-01 DO-02C Digital Output Channel 1 Selection
Selects the multi-function output selections for channel 1 of the DO-02C option.
For detailed information on these settings, refer to section H2, Digital Outputs, on page 88.
Setting
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
10
11
12
F5-02 DO-02C Digital Output Channel 2 Selection
Setting Range:
Factory Default:
Selects the multi-function output selections for channel 2 of the DO-02C option.
VS-616G5 Programming Manual
Description
During run 1 (factory default)
Zero speed
Fref/Fout agree 1
Fref/set agree 1
Frequency detection 1
Frequency detection 2
Inverter ready
DC bus undervoltage
Baseblock 1
Option frequency reference
Remote operation
Torque detection 1 (N.O.)
Loss of reference
DB overheat
Fault
Not used
Minor fault
Reset command active
Timer output
Same as F5-01
Zero speed (setting = "1")
DO-02 CH1 Select
Setting Description
13 Fref/Fout agree 2
14 Fref/set agree 2
15 Frequency detection 3
16 Frequency detection 4
17 Torque detection 1 (N.C.)
18 Torque detection 2 (N.O.)
19 Torque detection 2 (N.C.)
1A Reverse direction
1B Baseblock 2
1C Motor 2 selected
1D Regenerating
1E Restart enabled
1F Overload (OL1)
20 OH pre-alarm
30 Current/torque limit
31 Speed limit
33 Zero servo end
37 During run 2
- --
DO-02 CH2 Select
Section F: Option Parameters
F5 DO-02 Option Set-up
Open Loop Flux
V/f V/f w/PG
Vector Vector
A A A A
A A A A
71