Table of Contents
Advertisement
Section L: Operator Parameters
O2 Key Selections
O2-06 Digital Operator Disconnection Detection
If the digital operator is disconnected from the inverter, this parameter selects whether the inverter
detects this condition.
Setting
0
Detection is disabled. Operation continues (factory default).
1
Detection is enabled. When the inverter detects that the digital operator has been discon-
nected while running, the inverter coasts to stop and the error message "OPR Operator
Disconnected" is displayed on the digital operator, after it is connected again.
This function can only be activated when the run command comes from the digital operator.
O2-07 Operation Time Setting
Setting Range:
Factory Default:
Sets the initial value for the cumulative operation time. Operation time starts accumulating from the set
value. This is very useful for preventive maintenance purposes.
O2-08 Cumulative Operation Time Selection
Defines the operation time that accumulates in the timer.
Setting
0
Power-On time is the accumulated time (factory default).
The timer counts the time while the inverter power supply is turned ON as operation time.
1
Running time is the accumulated time. The timer counts the time while the inverter is running
as operation time.
O2-09 Initialization Mode Selection
Sets factory defaults to worldwide specifications.
Setting
After changing this setting, reinitialize the inverter in parameter A1-03. This initialization affects mar-
ket-driven parameter settings (motor-related parameters, carrier frequency, inverter rated current, etc.)
124
0 to 65535 Hours
0 Hours
0
Japanese specifications
1
American specifications (factory default)
2
European specifications
3
OMRON specifications
Oper Detection
Description
Elapsed Time Set
Elapsed Time Run
Description
Init Mode Sel
Description
A
A
A
A
A
A
A
A
A
A
A
A
VS-616G5 Programming Manual
A
A
A
A
Hide quick links:
Advertisement
Table of Contents
