YASKAWA VS-616G5 Series Programming Manual page 69

F4-01 Setting
18 Motor secondary current (Iq)
19 Motor excitation current (Id)
20 SFS output frequency
21 ASR input
22 ASR output
23 Speed deviation
24 PID feedback
25 Not Used
26 Voltage reference (Vq output)
27 Voltage reference (Vd output)
28-30 Not Used
31 Not Used
32 ACR(q) Output
33 ACR(d) Output
34-35 Not Used
36 PID Input Monitor
37 PID Output Monitor
38 PID Setpoint or Reference
F4-02 Analog Output Channel 1 Gain
Setting Range:
Factory Default:
Sets the channel 1 output gain for the analog output monitors. To obtain the output level, multiply the
monitor output level by the gain value set in F4-02.
VS-616G5 Programming Manual
Analog Output Channel 1 Selection (Continued)
Function
Monitors the calculated value of the motors secondary current. (Iq) The motors
rated secondary current corresponds to 100%. 10 V=Rated secondary current.
(0 to + 10 V output)
Monitors the calculated value of the motors excitation current. (Id) The motors
rated excitation current corresponds to 100%. 10 V=Rated excitation current. (0
to + 10 V output).
Monitors the output frequency after a soft start. This is the frequency without the
correction from compensation functions such as slip compensation. 10 V=Max.
frequency (0 to +/- 10 V possible)
Monitors the input to the speed control loop. The max. frequency corresponds to
100%. 10 V=Max. frequency (0 to +/- 10 V possible)
Monitors the output from the speed control loop. Analog monitor becomes 10 V/
max. output frequency with V/F control. In vector control the analog monitor be-
comes 10V= motor rated excitation current. (0 to +/-10V possible.)
Monitors the speed deviation within the speed control loop. The max. frequency
corresponds to 100%. 10 V=Max. frequency (0 to +/-10 V possible.)
Monitors the feedback value when the PID control is utilized. The input for the
max. frequency corresponds to 100%. 10 V= Max frequency.
(0 to +/-10 V possible.)
Monitors the inverters internal voltage reference value for the motors secondary
current control. 10 V= 200,400 or 575 VAC (0 to =/- 10 V possible.)
Monitors the inverters internal voltage reference value for the motors excitation
current control. 10 V= 200,400 or 575 VAC (0 to =/- 10 V possible.)
Monitors current control output value for the motors secondary current.
10 V= 100%.
Monitors current control output value for the motors excitation current.
10 V= 100%.
Monitors the input to the PID circuit. This is the PID reference + the PID reference
bias - the PID feedback. 10 V= Max frequency.
Monitors the output of the PID circuit. 10 V= Max frequency.
Monitors the PID setpoint. This is the PID setpoint + the PID setpoint bias.
10 V= Max frequency.
0.00 to 2.50
1.00
F4 AO-08/AO-12 Option Set-up
Description
--
--
--
--
AO CH1 Gain
Section F: Option Parameters
Open Loop Flux
V/f V/f w/PG
Vector Vector
A A A A
69