Advanced – IDE Configuration (AHCI Mode)
5.4.7
Menu Path
The IDE Configuration allows users to enable / disable the SATA controller as well
as the operational mode after the SATA controller is enabled. The following screen
indicates the functions available when the SATA hard drive is set to work in AHCI
mode.
BIOS Setting
SATA Controller(s)
SATA Test Mode
SATA Speed Support
SATA ODD Port
PA-3222 SERIES USER MANUAL
Advanced > IDE Configuration
IDE Configuration Screen – AHCI Mode
Options
- Disabled
- Enabled
- Disabled
- Enabled
- GEN1
- GEN2
- Port0 ODD
- Port1 ODD
Chapter 5 BIOS Setup
Description/Purpose
Enables or Disables the on-chip SATA
Device. Default: Enabled.
Enables or disables SATA Test Mode.
Gen1 mode sets the device to 1.5 Gbit/s
speed.
Gen2 mode sets the device to 3 Gbit/s
speed (in case it is compatible).
SATA ODD is Port0 or Port1
Page: 5-22