ESC E n
[Name]
Turn emphasized mode on / off.
ASCII
[Format]
Hex.
Decimal
0 ≤ n ≤ 255
[Range]
Initial Value n = 0
This command turns emphasized mode on or off by toggling the least significant
bit of n as followings:
[Description]
When the LSB of n is 0, the emphasized mode is turned off.
When the LSB of n is 1, the emphasized mode is turned on.
ESC G n
[Name]
Turn double-strike mode on/off.
ASCII
[Format]
Hex.
Decimal
0 ≤ n ≤ 255
[Range]
Initial Value n = 0
Specifies or cancels double printing.
Cancels double printing when n = <*******0>B.
Specifies double printing when n = <*******1>B.
n is effective only when it is the lowest bit.
[Description]
This printer is not capable of double printing, so the print is the same as
This command is enabled for ANK characters
ESC J n
[Name]
Print and feed paper.
ASCII
[Format]
Hex.
Decimal
0 ≤ n ≤ 255
[Range]
This command prints the data in the print buffer and feeds the paper [n X
vertical motion unit].
Sets the print position to the beginning of the next line after printing.
In standard mode, the printer uses the vertical motion unit (y).
[Description]
In page mode, this command functions as follows, depending on the starting
PA-3222 SERIES USER MANUAL
ESC E
1B
45
27
69
ESC G
1B
47
27
71
when using emphasized printing.
ESC J
1B
4A
27
74
position of the printable area:
(1) When the starting position is set to the upper left or lower right of the
printable area using ESC T, the vertical motion unit (y) is used.
n
n
n
n
n
n
n
n
n
Chapter 4 Software Utilities
Page: 4-23