Protech Systems PA-3222 User Manual page 109

 The maximum line spacing is 150mm {5.9 inches }. When the setting value
ESC L
[Name] Select page mode
ASCII
[Format]
Hex.
Decimal 27
[Range] N/A
 Enabled only when input with the top of line.
 Invalid when input by page mode.
 Returns to standard mode after the following commands are issued.
 Character expansion position has the starting point specified by ESC T
 This command switches the settings for the following commands the values
[Description]
 The following commands are enabled only when in page mode.
 The following command is ignored in page mode.
 The following commands are invalid in page mode.
 Recover to standard mode using ESC @ (initialize printer).
PA-3222 SERIES USER MANUAL
(2) When the starting position is set to the upper right or lower left of the
printable area using ESC T, the horizontal motion unit (x) is used.
exceeds the maximum, it is converted to the maximum automatically.
ESC L
1B 4C
76
a. FF (Print and recover to page mode)
b. ESC S (Select standard mode)
(Character print direction selection in page mode) in the printing region
designated by the ESC W (Set print region in the page mode) command.
of which can be set independently in standard mode and page mode to
those for page mode
a. Set space amount: ESC SP, FS S
b. Set line feed amount: ESC 2, ESC 3
a. ESC V : Specify/cancel character 90 degree clockwise rotation
b. ESC a : Position alignment
c. ESC { : Specify/cancel upside-down printing
d. GS W : Set print region width
a. GS (A : Test print
a. FS p : Print NV bit image
b. FS q : Define NV bit image
c. GS v 0 : Print raster bit images
d. GS L : Set left margin
Chapter 4 Software Utilities
Page: 4-24