Embedded Event Manager Actions - Cisco Catalyst 2960 series Configuration Manual

Action 12.2(25)S 12.3(14)T
12.2(18)SXF5
12.2(28)SB
12.2(33)SRA
Set or Yes Yes
modify a
named
counter
Set the -- --
state of a
tracked
object
Switch to a Yes Yes
secondary
RP

Embedded Event Manager Actions

The CLI-based corrective actions that are taken when event detectors report events enable a powerful on-device
event management mechanism. Some EEM actions are available on every Cisco IOS release, but most EEM
actions have been introduced in a specific release. For details of which EEM action is supported in each Cisco
IOS release, see the EEM Actions Available by Cisco IOS Release concept in the "Writing Embedded Event
Manager Policies Using the Cisco IOS CLI" or the "Writing Embedded Event Manager Policies Using Tcl"
modules. EEM supports the following actions:
• Executing a Cisco IOS command-line interface (CLI) command.
• Generating a CNS event for upstream processing by Cisco CNS devices.
• Setting or modifying a named counter.
• Switching to a secondary processor in a fully redundant hardware configuration.
• Requesting system information when an event occurs.
• Sending a short e-mail.
• Manually running an EEM policy.
• Publishing an application-specific event.
• Reloading the Cisco software.
• Generating an SNMP trap.
• Generating prioritized syslog messages.
• Reading the state of a tracked object.
• Setting the state of a tracked object.
12.4(2)T 12.2(18)SXF4 12.2(33)SXH
12.2(31)SB3 Cisco IOS
12.2(33)SRB Software
Modularity
Yes Yes Yes
Yes --
Yes Yes Yes
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Information About Embedded Event Manager
12.4(20)T 12.4(22)T 15.0(1)M
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
15E
XE 3E
Yes
Yes
Yes
1675