Cisco Catalyst 2960 series Configuration Manual page 2239

Command or Action
Step 3
interface interface-id
Example:
Switch(config)# interface gigabitethernet 1/0/1
Step 4 switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 5
switchport access vlan dynamic
Example:
Switch(config-if)# switchport access vlan
dynamic
Step 6
end
Example:
Switch(config)# end
Step 7 show interfaces interface-id switchport
Example:
Switch# show interfaces gigabitethernet 1/0/1
switchport
Step 8 copy running-config startup-config
Example:
Switch# copy running-config startup-config
Related Topics
Dynamic VLAN Assignments, on page 2152
Dynamic-Access Port VLAN Membership, on page 2153
Example: VMPS Configuration, on page 2162
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Purpose
Specifies the switch port that is connected to the end
station, and enters interface configuration mode.
Sets the port to access mode.
Configures the port as eligible for dynamic VLAN
membership.
The dynamic-access port must be connected to an end
station.
Returns to privileged EXEC mode.
Verifies your entries in the Operational Mode field of
the display.
(Optional) Saves your entries in the configuration file.
How to Configure VMPS
2157