Example: Removing A Vlan From A Port - Cisco Catalyst 2960 series Configuration Manual

Example: Removing a VLAN from a Port

This example shows how to remove VLAN 2 from the allowed VLAN list on a port:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport trunk allowed vlan remove 2
Switch(config-if)# end
Where to Go Next
After configuring VLAN trunks, you can configure the following:
• VLANs
Additional References
Related Documents
Related Topic
For complete syntax and usage information for the
commands used in this chapter.
Standards and RFCs
Standard/RFC
—
MIBs
MIB
All supported MIBs for this release.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Document Title
Catalyst 2960-X Switch VLAN Management
Command Reference
Title
—
MIBs Link
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
Where to Go Next
2149