Monitoring Ip Sla Operations - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Example:
Switch(config)# ip sla responder udp-echo
172.29.139.134 5000
Step 4 end
Example:
Switch(config)# end
Step 5 show running-config
Example:
Switch# show running-config
Step 6
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Related Topics
IP SLA Responder and IP SLA Control Protocol, on page 2028
Response Time Computation for IP SLAs, on page 2028
Restrictions on SLAs, on page 2025
Monitoring IP SLA Operations, on page 2031

Monitoring IP SLA Operations

The following table describes the commands used to display IP SLA operation configurations and results:
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
• tcp-connect—Enables the responder for TCP connect
operations.
• udp-echo—Enables the responder for User Datagram
Protocol (UDP) echo or jitter operations.
• ipaddress ip-address—Enter the destination IP address.
• port port-number—Enter the destination port number.
The IP address and port number must match those
Note
configured on the source device for the IP SLA
operation.
Monitoring IP SLA Operations
2031