Default Vmps Client Configuration - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
How to Configure VMPS
Default VMPS Client Configuration
The following table shows the default VMPS and dynamic-access port configuration on client switches.
Table 197: Default VMPS Client and Dynamic-Access Port Configuration
Feature
VMPS domain server
VMPS reconfirm interval
VMPS server retry count
Dynamic-access ports
How to Configure VMPS
Entering the IP Address of the VMPS
If the VMPS is being defined for a cluster of switches, enter the address on the command switch.
Note
Before You Begin
You must first enter the IP address of the server to configure the switch as a client.
SUMMARY STEPS
1. enable
2. configure terminal
3. vmps server ipaddress primary
4. vmps server ipaddress
5. end
6. show vmps
7. copy running-config startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2154
Default Setting
None
60 minutes
3
None configured
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
