Manually Assigning Ip Information To Multiple Svis - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Download Configuration Files at Reboot^C
Step 5
end
Example:
Switch(config-if)# end
Step 6 show boot
Example:
Switch# show boot
Related Topics
Example: Configuring a Switch to Download Configurations from a DHCP Server, on page 1585

Manually Assigning IP Information to Multiple SVIs

This task describes how to manually assign IP information to multiple switched virtual interfaces (SVIs):
SUMMARY STEPS
1. configure terminal
2. interface vlan vlan-id
3. ip address ip-address subnet-mask
4. exit
5. ip default-gateway ip-address
6. end
7. show interfaces vlan vlan-id
8. show ip redirects
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Perform Switch Setup Configuration
Purpose
Returns to privileged EXEC mode.
Verifies the configuration.
Purpose
Enters global configuration mode.
1577