Example: Enabling Vtp On The Interface - Cisco Catalyst 2960 series Configuration Manual

Where to Go Next
VTP Modes, on page 2086

Example: Enabling VTP on the Interface

To enable VTP on the interface, use the vtp interface configuration command. To disable VTP on the interface,
use the no vtp interface configuration command.
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# vtp
Switch(config-if)# end
Example: Creating the VTP Password
The follow is an example of creating the VTP password.
Switch(config)# vtp password mypassword hidden
Generating the secret associated to the password.
Switch(config)# end
Switch# show vtp password
VTP password: 89914640C8D90868B6A0D8103847A733
Where to Go Next
After configuring VTP, you can configure the following:
• VLANS
• VLAN Trunking
• VLAN Membership Policy Server (VMPS)
• Voice VLANs
Additional References
Related Documents
Related Topic
For complete syntax and usage information for the
commands used in this chapter.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2106
Document Title
Catalyst 2960-X Switch VLAN Management
Command Reference