Examples: Configuring Sdm Templates - Cisco Catalyst 2960 series Configuration Manual

number of IPv6 multicast groups:
number of directly-connected IPv6 addresses:
number of indirect IPv6 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
number of IPv6 policy based routing aces:
number of IPv6 qos aces:
number of IPv6 security aces:
Switch#

Examples: Configuring SDM Templates

This example shows how to configure the VLAN template:
Switch(config)# sdm prefer lanbase-routing
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Switch(config)# sdm prefer dual-ipv4-and-ipv6 default
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Additional References for SDM Templates
Related Documents
Related Topic
SDM commands
Standards and RFCs
Standard/RFC
None
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
Additional References for SDM Templates
0.875k
80
0.25K
0.75K
32
0
0.375k
0.375k
0
0.125k
0.25K
Document Title
Catalyst 2960-X Switch System Management
Command Reference
Title
—
1595