9 WHEN COMMUNICATING DATA USING THE MC PROTOCOL
9.4 Remote RUN/STOP, PLC model name code read
9.4.1 Commands and control contents
–
Function
Remote RUN
Remote STOP
PLC model name read
9 - 35
This function is used to remotely RUN/STOP a PLC and read the model name of a
PLC from an external device.
This section describes the commands and control contents of the control procedure
when controlling the status of the PLC.
(1) Commands
Command / Response type
13
H
14
H
15
H
Requests remote RUN (execute operation)
Executes a forced RUN regardless of the RUN/STOP switch status of PLC.
Requests remote STOP (stop operation)
Executes a forced STOP regardless of the RUN/STOP switch status of PLC.
Request to read the model name of the PLC.
MELSEC-F
Processing
9 - 35