Mitsubishi MELSEC-F User Manual page 254

11 TROUBLESHOOTING
Error code
(abnormal Description of error
code)
C124 A response from the SMTP server timed out.
H
C125 Forcefully disconnected from the SMTP server.
H
C126 Could not close the SMTP server.
H
Closing the SMTP server gave an error
C127
H
response.
Communication channel is closed because the
C130
H
service is not available.
The SMTP server was performing processing
C131
H
and an error response was received.
The SMTP server was performing processing
C132 and an error response was received.
H
(Local error)
The SMTP server was performing processing
C133 and an error response was received.
H
(Insufficient memory area)
C134
H
System error
to
• The OS detected any error.
C137
H
The SMTP server was performing processing
C138
and an error response was received.
H
(Mailbox not found)
System error
C139
H
• The OS detected any error.
The SMTP server was performing processing
C13A and an error response was received.
H
(Exceeded the allocation of memory area)
The SMTP server was performing processing
C13B and an error response was received.
H
(Illegal mail box name)
System error
C13C
H
• The OS detected any error.
C140 Could not open the POP3 server.
H
Cannot communicate with the POP3 server.
C141
H
(Error response)
Cannot communicate with the POP3 server.
C142
H
(Abort)
Cannot communicate with the POP3 server.
C143
H
(Reset response)
Could not receive a response from the POP3
C144
H
server.
11 - 29
Error handling
• Check whether or not the SMTP server is
faulty.
• Check whether or not there is too much load
on the network.
• Check whether or not the SMTP server is
faulty.
• Check whether or not the SMTP server is
faulty.
• Check whether or not there is too much load
on the network.
• Check whether or not the SMTP server is
faulty.
• Check the status of the SMTP server.
• Check if a user name not registered in the
server was designated.
• Send again after arbitrary set time has
passed.
• Check the status of the SMTP server.
• Check the status of the SMTP server.
( 1)
• Check that the Ethernet module's mail
address is set correctly.
( 1)
• Check the status of the SMTP server.
• Check that the Ethernet module's mail
address is set correctly.
( 1)
• Check that the port number of the POP3
server = 110. (For the Ethernet module, this
is fixed to 110.)
• Check whether or not it is possible to
communicate with the POP3 server using the
Ping command.
• Check if the POP3 server is busy.
• Check if the POP3 server is busy.
• Check if the POP3 server is busy.
• Check whether or not the POP3 server is
faulty.
• Check whether or not there is too much load
on the network.
• Check that the correct password is being sent
to the POP3 server.
MELSEC-F
Storage destination
BFM# BFM# BFM# BFM# BFM#
105 124 125 126
BFM#
229 22649
11 - 29