Checking The Error Information By The Buffer Memory Batch Monitoring Function - Mitsubishi MELSEC-F User Manual

11 TROUBLESHOOTING

11.3 Checking the error information by the buffer memory batch monitoring function

11 - 10
It is explained here how the Ethernet module errors can be checked from GX
Developer.
Error codes stored in the buffer memory of the Ethernet module can be monitored
using the "Buffer memory batch monitoring" function of GX Developer.
[Operating procedure]
(Step 1) Select [Online] – [Monitor] – [Buffer memory batch] from the GX Developer
menu bar, and start the "Buffer memory batch monitoring" screen.
(Step 2) Enter [Module start address:].
Assign a special module number to each base module following the order that
0 is assigned to the rightmost module, 1 to the second rightmost module, and
goes same up to 7.
However, for FX
first special module will be assigned with No.1.
(Step 3) Enter [Buffer memory start address:].
Enter the buffer memory address to be monitored, using the selected input
format (decimal/hexadecimal).
For a list of the buffer memory addresses where error codes are stored, see
Section 11.4, "Error Code List".
(Example)
When monitoring the initial abnormal code (BFM #105):
Enter "105" + "decimal"
(Step 4) Click the Start Monitor button.
The contents of the buffer memory after the specified address are displayed.
(In case of the above example, the contents of 105
addresses are displayed.)
POINT
To see if the PLC base module recognizes the FX
#30.
If BFM #30's value is K7130, the FX
NOTE
The display format can by modified as follows:
Monitor format : Bits & words/ Multiple bit points/ Multiple word points
Display : 16-bit integer/32-bit integer/real number/ASCII character
Numerical value : Decimal/hexadecimal
For details, refer to the "Operating Manual" for GX Developer.
C-32MT-LT which incorporates the CCLink/LT function, the
3U
-ENET is being recognized.
3U
MELSEC-F
and succeeding
H
-ENET or not, monitor BFM
3U
11 - 10