Operational Settings - Mitsubishi MELSEC-F User Manual

4 SETTINGS AND PROCEDURES PRIOR TO OPERATION

4.6 Operational Settings

Setting name
Communication data code
TCP Existence confirmation setting
Send frame setting
Initial Timing
IP Address
[Initial processing parameter setting area (For re-initialization)]
b15 b14 b13 b12
4 - 11
This section explains how to set the operations parameters.
BFM number [Decimal]
(bit number)
24 (b1) Select the communication data code.
24 (b4) Select the existence check method for TCP communication
24 (b5) Select the frame format to send
24 (b8) Open setting
0 to 1 IP address of the local station.
b11 b10 b9 b8 b7
(1) Communication data code (BFM#24 b1)
(a) Select the format of the communication data when communicating with an
external device.
Name of setting
Binary code
ASCII code
(b) For more details on the data communication codes, see Section 3.2, "Data
Codes for Communication."
Setting description
b6 b5 b4 b3 b2
Communicate using binary data.
Communicate using ASCII data.
MELSEC-F
Setting range/selection
OFF : Binary code
ON : ASCII code
ON : Use KeepAlive
OFF : Use Ping
OFF : Ethernet (V2.0)
ON : IEEE 802.3
OFF : Do not wait for OPEN
ON : Always wait for OPEN
b1 b0
(1) Communication data code setting
(2) TCP Existence confirmation setting
(3) Send frame setting
(4) Initial timing setting
Description of setting
4 - 11