Mitsubishi MELSEC-F User Manual page 224

10 USING THE E-MAIL FUNCTION
BFM number
Decimal
(Hexadecimal)
10333
Mail sending command
(285DH)
10334
Mail sending status
(285EH)
10336
Sending result of e-mail
(2860H)
10337
Destination Address of e-mail
(2861H)
10338
Attached file format
(2862H)
10339 to 10402
Subject
(2863 to 28A2H)
10403
Word count of attached file
(28A3H)
10404 to 12451
Main text data
(28A4 to 30A3H)
10 - 25
The table below shows the buffer memory to be used for sending mail.
Item
Start mail sending (0001H)
Ignored (0000H)
Initial status (0000H)
Mail sending normal completed (0001H)
Mail sending abnormal completed (0002H)
Mail being sent (8000H)
Sending destination address 1
Sending destination address 10
Turns the bit of mail destination address to ON.
Sending destination address 1
Sending destination address 10
Write 0004H for sending the attached file as main text.
Stores a subject (maximum 128 characters)
Subject consists of the send destination number and the character data designated
by the sequence program.
(It is not converted to ASCII format.)
The Subject should be designated in ASCII characters in the sequence program.
When the subject consists of less than 128 characters, write "\0" at the end of the
subject.
Designates the word count of main text (0 to 256)
Stores a main text or an attached file
Main texts are not converted to ASCII format by the Ethernet module.
It should be designated in ASCII characters in the sequence program.
The following binary code data is processed as control codes:
0D0AH: Line feed code CR + LF
00H: End of main text
It is recommended to use 78 characters or less in a single line of main text.
(Be sure to add a line feed code CR + LF (0D0A
Description
Success (b0: ON) / Failure (b0: OFF)
to
Success (b9: ON) / Failure (b9: OFF)
Enable (b0: ON) / Disable (b0: OFF)
to
Enable (b9: ON) / Disable (b9: OFF)
) at the end of the main text lines.)
H
MELSEC-F
10 - 25