Router Relay Parameter - Mitsubishi MELSEC-F User Manual

5 COMMUNICATION PROCEDURE

5.3 Router Relay Parameter

Setting item name BFM number (Decimal)
Router relay function
Sub-net mask pattern
Router IP address
5 - 13
This section explains the router relay parameter.
2
Select whether the router relay function is not used or is used.
(b4, b5)
512, 513 Set the sub-net mask.
514, 515 Set the IP address of the router to be routed through.
NOTE
When making settings with the FX Configurator-EN (GX Developer), select [Router
Relay Parameters] from the initial screen and adjust the settings at the [Ethernet
Router Relay Parameter Settings] screen.
(1) Router relay function (BFM#2 b4,b5)
(a) Set whether the router relay function will be used or not.
The router relay function is not needed when the FX
communicates with the target device on the same Ethernet network (the
subnet address of the IP address is the same).
(b) The router relay function allows communication with devices on other
Ethernet networks via routers and gateways.
(The router relay function does not mean a function with which the FX
ENET acts as a router.)
(c) One router can be set for the router relay function.
Description of setting
MELSEC-F
Setting range/options
00 : Use
01 : Not used
C0000000 to FFFFFFFC
H H
Other than 00000000 and FFFFFFFF
H
-ENET
3U
5 - 13
H
-
3U