Table of Contents
Advertisement
Operating conditions
Read and observe
on page 254 first.
The system can intervene when the following basic conditions are present.
Lane Assist is activated and the boundary line is detected at least on one
side of the lane
» page
251.
ACC is activated and the regulation
Traffic sign recognition
Introduction
The traffic sign recognition (following known as system) shows certain traffic
signs (e.g. speed limits) on the display of the instrument cluster and if necessa-
ry warns against excessive speeds.
WARNING
Please take note of the general points relating to the use of assistance
■
systems
» page 220,
in section Introduction.
Vertical traffic signs must always take precedence over the traffic signs
■
shown in the display. The driver is always responsible for correctly assess-
ing the traffic situation.
The speed specifications in the displayed road signs refer to the custom-
■
ary national speed units. For example, the display may relate to km/h or
mph depending on the country in question.
WARNING
The traffic signs may not be displayed or displayed incorrectly in the sys-
tem e.g. in the following situations.
When visibility is poor, (e.g. fog, heavy rain, thick snowfall).
■
The sensor is blinded by the sun or oncoming traffic.
■
The field of view of the sensor is limited by an obstacle or a preceding ve-
■
hicle.
Travelling at high speed.
■
The traffic signs are covered (e.g. by trees, snow or dirt).
■
The traffic signs are not standard (round with a red border) or are dam-
■
aged.
» page 241
follows.
WARNING (Continued)
The traffic signs are attached to flashing neon signs.
■
The traffic signs were changed (the navigation data are out of date).
■
Note
The system is only available in some countries.
Settings in Infotainment
Read and observe
on page 255 first.
›
In the infotainment system, in menu
er assistance.
Dynamic Road Sign Display - Settings for the Dynamic Road Sign Display
■
Show in instrument cluster - Activation/deactivation of the additional traffic
■
signs in the display of the instrument cluster
Speed warning: - Setting a warning when the speed limit is exceeded
■
Warning at over - Setting warning timing with the option to exceed the speed
■
limit in a range from 0 to 20 km / h
Trailer recognition
■
Show road signs relevant to trailers - Activation/deactivation of the display of
■
road signs relevant to trailers
Use for route calculation - Activation / deactivation of taking the trailer into ac-
■
count for route calculation in navigation
Maximum speed for trailer - Set the top speed for towing a trailer
■
Operation
/ tap on function surface → Driv-
Fig. 310
Sensor for Dynamic Road Sign
Display
Assist systems
255
Advertisement
Table of Contents
