Table of Contents
Advertisement
Estimated time of arrival at destination / remaining driving time to desti-
nation
Remaining distance to the destination
Chosen route type (economic, fastest, shortest)
C
Current vehicle position (address / GPS coordinates)
D
The display of the arrival time or the remaining driving time can be adjusted as
follows.
▶
In the Navigation main menu, tap on the functional surface → Advanced set-
tings → Time display:.
Several route destinations
In the route plan, the following information is displayed at the respective desti-
nations» Fig. 247
- .
Area with functional surfaces
A
Stopover (with sequential number)
Final destination
Estimated time of arrival at destination / stopover
Driving distance to destination / stopover
Substitution of destinations among themselves
Delete the destination
Continuation of the route guidance from the selected target (previous
waypoints are skipped)
Display the destination details
Insert destination into the route
In the area
, tap on function surface Name destination and enter a new desti-
▶
A
nation.
▶
or: In area
, tap the function surface Destinations and select a destination
A
from the list of stored destinations.
Each additional destination is added to the list as the first subsequent destina-
tion route.
Change positions of destinations with each other
▶
The relevant function surface and move the destination to the desired po-
sition.
With destinations on the route already reached, the note Dest. reached is dis-
played below the destination name. It is not possible to change the position of
these destinations with each other.
» page 198
Store route
In the area
, tap the functional surface Save.
▶
A
▶
Save the edited route as a new route or replace the existing saved route.
The route is stored in the route list
Stop route guidance
▶
In the area
, tap the functional surface Stop.
A
Route change in the map
Only valid for Infotainment Columbus.
Fig. 248 Route change in the map / route transit point
A route in which there are no intermediate targets can be changed during
route guidance by inserting a transit point.
Add a transit point
›
In the Navigation main menu, tap on the function surface → Change route in
map.
›
Touch the screen in the route field and move the cross-point to the desired
location on the map, e.g.
, move
A
The transit point
is added to the route
B
›
Tap on the function surface .
Then a new route is calculated and route guidance starts.
Customise transit point
›
In the Navigation main menu, tap on the function surface → Change route in
map.
›
Touch the transit point
and move to a different location on the map.
B
›
Tap on the function surface .
» page
202.
» Fig.
248).
» Fig.
248.
Navigation
201
Advertisement
Table of Contents
