WARNING
The CD/DVD player is a laser product.
■
This laser product was classified as a Class 1 laser product on the date of
■
manufacture in accordance with national/international standards DIN EN
60825-1: 2008-05 and DHHS Rules 21 CFR, Sub-chapter J. The laser used
in this class 1 laser product is so weak that there is no risk of danger when
operated correctly.
This product is designed such that the laser is restricted to the inside of
■
Infotainment. However, the installed laser could be classified in a higher
class were the housing to be removed. For this reason, never remove Info-
tainment housing.
CAUTION
Be sure to remove the CD/DVD before you try to insert a new CD/DVD. Oth-
■
erwise you can damage the drive inside Infotainment.
Only insert in the CD/DVD drive original audio CDs/video DVDs or standard
■
CD-R/RWs or DVD±R/RWs.
Do not affix anything to the CD/DVDs!
■
If the ambient temperature is too high or too low, the CD / DVD playback
■
may not work.
Damp (condensation) may affect Infotainment in cold weather or high hu-
■
midity. This can cause the CD to jump or impair the play function. Once the
moisture has dissipated, playback is fully functional again.
Note
After pressing the button it takes a few seconds for the CD / DVD to be
■
ejected.
On uneven or unpaved roads, playback jumps may occur.
■
If the CD/DVD is physically damaged, is not readable or is inserted incorrect-
■
ly the following message is displayed Error: CD/DVD.
It is possible that CD/DVDs protected by copyright cannot be played back at
■
all or only in certain circumstances.
SD card
›
Insert the SD card in the slot in the direction of arrow (with the cut end fac-
ing right), until it "locks"
» Fig. 201
›
To remove the SD card, tap on the Media main menu function surface →
Tap on Remove safely.
›
Press on the inserted SD memory card. The SD card "jumps" into the eject
position.
CAUTION
Do not use an SD card with a broken write protection slide - there is a risk of
■
damage to the SD card reader!
When using an SD card with an adapter, vehicle vibrations might cause the
■
card to fall out of the adapter.
USB input
Installation location of the USB input and information regarding its use
» page
97.
Fig. 201
Columbus, Amundsen, Bolero:
insert SD card
Fig. 202
Swing: insert SD card
or
» Fig.
202.
Media
157