Table of Contents
Advertisement
Anti-theft wheel bolts
The anti-theft wheel bolts protect the wheels from theft. The upper section
» Fig. 338
must be used to loosen/tighten these.
B
›
Insert the upper section
on the anti-theft wheel bolt
B
›
Insert the wrench on the attachment
wheel bolt.
›
Removing the upper section.
The attachment for the anti-theft wheel bolts must always be kept in the
vehicle in case of a possible wheel change!
For wheel trims supplied ex-factory or from ŠKODA Original Accessories, the
anti-theft wheel bolt should be installed in the position marked on the back of
the wheel trim.
Note
We recommend that you retain the label with the code number. A replace-
ment upper section can be acquired from ŠKODA original parts based on this.
Loosening/tightening wheel bolts
Fig. 338
Anti-theft wheel bolt and upper
section
until it stops.
A
until it stops and loose/tighten the
B
Fig. 339
Loosening the wheel bolts
›
Push the wheel wrench onto the wheel bolt to the stop. Use the associated
upper section for the anti-theft wheel bolts
›
To loosen the screws, hold the wrench end and turn the screw about one
turn in the direction of arrow
» Fig.
›
To tighten the screws, hold the wrench end and turn the screw against the
direction of the arrow
» Fig.
339, until it is tight.
WARNING
If it proves difficult to undo the bolts, carefully apply pressure to the end of
the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing - risk of accident.
Raising the vehicle
Fig. 341 Attach lifting jack
The procedure for lifting the vehicle is valid for all body versions.
Before the vehicle is raised, the safety instructions must be observed
» Fig. 338
on page 291.
339.
Fig. 340
Jacking points for the jack
Emergency equipment and self-help
»
.
291
Advertisement
Table of Contents
