Table of Contents
Advertisement
Fig. 295 Segment display: Examples of Speed Limiter status displays
Read and observe
on page 239 first.
Speed limiter status displays
» Fig.
Speed limit is set, control is inactive (in the colour display the digits of
speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-
lighted).
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for start of control
The Speed Limiter is activated.
The current speed is greater than approx. 30 km/h.
After starting the system, the current speed is set as the speed limit, the warn-
ing light
lights up in the instrument cluster.
Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to over-
take), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light
flashes in the instrument cluster.
The regulation is resumed once the speed has fallen below the set limit.
240
Driving
294,
» Fig. 295
Operation description - Variant with GRA
Read and observe
on page 239 first.
Overview of the control elements of the speed limiter
Activate CCS (required condition for the subsequent activation of
A
the speed limiter)
To activate the speed limiter, set the switch to position , then
press
.
D
Interrupt control (sprung position)
Speed Limiter disable (set limit delete)
Take control again
/ increase speed limit - press (in increments of
B
a)
1 km/h), hold (in increments of 10 km/h)
Start control/ reduce speed limit - press (in increments of 1 km/h),
C
hold (in increments of 10 km/h)
Switching between CCS and speed limiter
D
a)
If no speed limit is set, the current speed is set as the speed limit.
Note
By pressing the button
D
» Fig. 296
the CCS is activated.
Fig. 296
Controls the speed limiter (var-
iant with GRA)
» Fig. 296
during the regulation this is cancelled and
Advertisement
Table of Contents
