Table of Contents
Advertisement
The vehicle speed is over 60 km/h or for some countries more than 40
km/h.
The windscreen is clean in the sensor area.
System on/off
Read and observe
and
Switch on the system
›
Push the lever into the sprung position
light lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position
. The warning light goes out. The high beam turns off.
B
›
If the high beam is is not switched on automatically, move the lever into the
sprung position
. The warning light goes out. The high beam turns on.
A
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
Interior lighting
Introduction
The inner lighting also works if the ignition is switched off. With the ignition
switched off, the lights will automatically switch off after approximately after
10 minutes.
Fig. 72
Operating lever: Headlamp as-
sistant
on page 78 first.
» Fig.
72. The following indicator
A
Operation of the lights from the front seats
Switch on/off (by pressing the relevant switch)
Automatic operation
A
Rear lighting
B
Front and rear lighting
C
Passenger light
D
Automatic operation - switch
The system is turned on when any of the following is present.
▶
The vehicle is unlocked.
▶
One of the doors is opened.
The ignition key is removed.
▶
The system is turned off when any of the following is present.
▶
The vehicle is locked.
The ignition is switched on.
▶
About 30 seconds after all the doors have been closed.
▶
Interior light, rear
Fig. 73
Operation of the lights from the
front seats
» Fig. 73
Fig. 74
Interior lights at the rear: Variant
1
Lights and visibility
79
Advertisement
Table of Contents
