Table of Contents
Advertisement
Connect / disconnect
›
Swing out the tow bar
» page
258.
›
Place the trailer (the accessory) onto the ball head.
›
Open the socket cap and insert the plug of the trailer (accessories) into the
13-pin socket
» Fig.
315. (If the trailer / accessories have a 7-pin connec-
A
tor, use a corresponding reduction piece from the ŠKODA Original Accesso-
ries).
›
Suspend the breakaway cable of the trailer at the safety eyelet
breakaway cable must sag in all trailer settings in view of the vehicle).
Uncoupling takes place in reverse order.
Exterior mirrors
You should have additional exterior mirrors fitted if you are not able to see the
traffic behind the trailer using the standard rear-view mirrors.
Headlights
The front of the vehicle may lift up when a trailer (accessory) is being towed
and the headlights may dazzle other road users. Set the range of the headlights
» page
74, Operating the lights
.
1)
Power supply of the trailer / accessory power system
In the electrical connection between the vehicle and trailer (accessory), the
trailer (accessories) is supplied with power from the vehicle (with ignition
switched on and off).
With the engine switched off, the vehicle battery is discharged by the connec-
ted consumers.
At low charge state of the vehicle battery, the power supply to the trailer (ac-
cessories) is interrupted.
Trailer
The permissible trailer load must not be exceeded under any circumstances.
1)
Applies to vehicles with xenon headlights.
260
Driving
WARNING
An improperly connected electrical installation of the trailer (accessories)
■
may result in an accident or serious injury from electrical shock.
Do not make any adjustments to the electrical installation of the vehicle
■
and the trailer (accessories) - risk of an accident or serious injury from elec-
trical shock.
After the electrical connection between the vehicle and trailer (accesso-
■
(the
B
ry) the trailer / accessory lights should be checked for function.
Never use the securing eye to tow - risk of accident!
■
CAUTION
An improperly connected electrical installation of the trailer (accessories) can
■
lead to the inoperability of the vehicle electronics.
The total power consumption of all the connected loads to the trailer power
■
supply must not exceed 350 watts, otherwise there is a risk of damage to the
electrical system of the vehicle.
Loading a trailer
Correct the tyre inflation pressure on the vehicle for "full
Distribution of the cargo
Distribute the cargo in the trailer in such a way that heavy items are located as
close to the trailer axle as possible. Secure the load from slipping.
The distribution of the weight is very poor if your vehicle is unladen and the
trailer is laden. Drive with particular caution if you cannot avoid driving with
this combination.
WARNING
Sliding cargo can significantly adversely affect stability and driving safety -
risk of accident!
load"» page
283.
Advertisement
Table of Contents
