Table of Contents
Advertisement
Operation description
Read and observe
on page 238 first.
Overview of the CCS controls
Activate CCS (regulation deactivated)
A
Interrupt control (sprung position)
Deactivate CCS (delete set speed)
Take control again
/ Increase speed
B
a)
Launch control / reduce speed
C
Switching between CCS and speed limiter
D
a)
If no speed is set the current speed is adopted.
After the start of the regulation, the CCS regulates the vehicle to the current
speed and the warning light
illuminates in the instrument cluster.
The automatic control interruption occurs if any of the following conditions
are met.
▶
The brake pedal is operated.
▶
When one of the brake assist systems (e.g. ESC) intervenes.
Through an airbag deployment.
▶
WARNING
Always deactivate the cruise control system after use to prevent the sys-
■
tem being switched on unintentionally.
The control does not resume if the set speed for the existing traffic con-
■
ditions is too high.
Fig. 293
Cruise control system controls
» Fig. 293
» page 239
Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the button
» Fig. 293
D
■
and the Speed Limiter is activated.
Speed limiter
Introduction
The Speed Limiter limits the maximum driving speed to the set speed limit.
The speed limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter prevents a potential set speed limit
excess is referred to as Regulation.
WARNING
The general information relating to the use of assistance systems must be
observed
» page 220,
in section Introduction.
Function
Fig. 294 MAXI DOT display (monochrome): Examples of Speed Limiter
status displays
during the regulation this is cancelled
Assist systems
239
Advertisement
Table of Contents
