Table of Contents
Advertisement
Note
If you want to stow the roll-up luggage compartment cover and the multifunc-
tion pocket at the same time, then it is necessary that the rear part of the roll-
up luggage compartment covers the multifunction pocket.
Removable light
Fig. 157 Removing light/inserting light
Read and observe
and
The light is located on the left side of the luggage compartment and is used to
light the luggage compartment or as a portable light.
The lamp is fitted with magnets. As a result, this can, for example, be fitted to
the vehicle body.
Description of the light
» Fig. 156
Button to turn on / off the light
A
Part that lights up when the lamp is in the mount
B
Part that lights up when the lamp is not in the mount
C
116
Using the system
Fig. 156
Removable light
on page 108 first.
If the light is in the mount, this will illuminate when the boot lid is opened.
›
To remove, hold the light in the area
» Fig.
157.
1
›
To switch on the removed light, press button
again will switch it off.
›
To insert, first of all insert the light with the rear part
» Fig. 157
and then push the light in the direction of arrow
clicks into place.
If the light is not switched off and is correctly inserted in the mount, the LED
diodes in the front part of the light
If the lamp is not correctly inserted into the holder, this does not light up when
the boot lid is opened and the rechargeable batteries are not charged.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries. The bat-
teries are charged continuously with the engine running (to fully charge the
battery takes approximately 3 hours).
Replace batteries
» page
298.
CAUTION
The light is not waterproof, so it must be protected from humidity - otherwise
there is risk of damage.
Class N1 vehicles
Read and observe
and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the
load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
and swivel in the direction of arrow
D
» Fig.
156. Pressing the light
A
into the mount
E
until it audibly
2
» Fig. 156
are automatically switched off.
C
on page 108 first.
Advertisement
Table of Contents
