›
To activate/deactivate the acoustic confirmation of a recognised gesture,
tap the sensor field
and then the function surface → Screen → Audible
hand gesture feedback.
Visual confirmation of the gesture
When the function is switched on and a gesture has been recognised, Infotain-
ment shows an animation with the bottom bar moving in the direction of the
hand movement.
›
To activate/deactivate the visual confirmation of a recognised gesture, tap
the sensor field
and then the function surface → Screen → Visual hand
gesture feedback.
Switching Infotainment on/off
Only valid for Infotainment Columbus.
›
To switch on Infotainment, press
›
To switch off Infotainment, hold
Applies to Infotainment Amundsen, Bolero, Swing
›
To power on/off Infotainment, press
Automatic switch-on of Infotainment
If Infotainment was not turned off with
it will automatically switch on when the ignition is switched on.
Automatic switch-off of Infotainment
If the vehicle key is pulled out of the ignition lock while Infotainment is switch-
ed on, Infotainment will switch off automatically.
If the vehicle is fitted with the starter button, Infotainment will switch off au-
tomatically after the engine is switched off and the door is opened.
With the ignition off, Infotainment will automatically turn off after about 30
minutes.
Infotainment turns off automatically under certain circumstances. Infotain-
ment informs of this via a text message on the Infotainment screen.
Restart Infotainment
If Infotainment does not respond (if it "freezes") This can be restarted by hold-
ing
for longer than 10 s.
134
Infotainment
.
.
.
before the ignition was turned off,
Show time and date on the screen
Standby mode
With the ignition off and infotainment (standbyMode), it is possible to display
the time and date in the Infotainment screen.
Applies to Infotainment Columbus, Amundsen, Bolero
To switch the time and date display on/off, press the
▶
then tap the function surface → Screen → Show clock in standby mode.
Applies to Infotainment Swing
To switch the time and date display on/off, press the
▶
the function surface Screen → Show clock in standby mode.
The display mode can be changed by moving your finger sideways across the
screen (does not apply to Infotainment Swing).
"Screen off" mode
With the ignition on and functions Screen off (in 10 s) and Display clock when screen
is off
» page 140
enabled, it is possible to display the time and date when the
Infotainment screen is switched off.
The display type depends on the display mode selected in standby mode (does
not apply to the Infotainment Swing).
Adjusting the volume
Every change in volume is displayed on the screen.
Only valid for Infotainment Columbus.
›
To increase the volume, tap the function surface
›
To decrease the volume, tap the function surface
›
To activate/deactivate the mute setting, tap the sensor field
Applies to Infotainment Amundsen, Bolero, Swing
›
To increase the volume, turn the controller
›
To reduce volume, turn the controller
›
To mute, turn the controller
The following symbol appears in the display when the sound is muted .
If playback was coming from a source in the Media menu at the time of mut-
ing, then playback will be stopped (not applicable to AUX).
sensor field and
button, then tap
.
.
clockwise.
anticlockwise.
to the left to 0.
.