Parameter Settings For The Oem - Siemens RVA63.280 Basic Documentation

Description
Setting
Example
Siemens Building Technologies
Landis & Staefa Division
2.6

Parameter settings for the OEM

Boiler-specific settings and protective functions for the boiler manufacturer.
Buttons Explanation
1
Press one of the line selection buttons UP/DOWN.
This will take you directly to the programming mode
"End-user".
Press both line selection buttons for at least 9 seconds.
2
A special display for entering the code will appear.
9 s
Press buttons
3 CODE
combination of the access code.
If the combination of buttons is correct, you reach the
programming mode "OEM".
If the code has been entered incorrectly, the display will
change to the "Parameter settings for the heating
engineer".
Press the line selection buttons to select the required
4
line.
The parameter list on the next 2 pages contains all
available lines.
Press the + or - button to set the required value.
5
The setting will be stored as soon as you leave the
programming mode or change to another line.
The parameter list on the next 2 pages contains all
settings that can be made.
By pressing any of the operating mode buttons you leave
6
the programming mode "OEM".
If no button is pressed for about 8 minutes, the controller
will automatically return to the operating mode selected
last.
Whether correct or incorrect, each push of a button will be adopted as a digit of the
code. As a confirmation, the respective digit changes to 1.
Basic Dokumentation RVA63.280, RVA53.280
and
è
Wrong code:
è
Note:
to enter the required
Line
• • •
continuo
us
display
29/184
CE1P2374E
19.04.2001