Commissioning; Functional Checks - Siemens RVA63.280 Basic Documentation

Prerequisites
Output test
Siemens Building Technologies
Landis & Staefa Division
2.3

Commissioning

To commission the controller:
• Make certain that mounting and electrical installation are in compliance with the
relevant requirements
• Make all plant-specific settings as described in section "Parameter settings"
• Reset the attenuated outside temperature
• Make the functional checks
2.3.1

Functional checks

To facilitate commissioning and fault tracing, the controller allows output and input tests
to be made. With these tests, the controller's inputs and outputs can be checked.
Buttons Explanation
1 Press one of the line selection buttons.
This will take you to the programming mode.
2 Press both line selection buttons for at least 3
seconds.
This will take you to the programming mode "Heating
engineer" and, at the same time, to the output test.
3 Press the + or - button repeatedly, which will take you
one test step further:
Test step 0
Test step 1
Test step 2
Test step 3
Test step 4
Test step 5
Test step 6
Test step 7
Test step 8
Test step 9
Test step 10
4 By pressing any of the operating mode or line
selection buttons, you leave the programming mode
and thus the output test.
Note:
If no button is pressed for about 8 minutes, the
controller will automatically return to the operating
mode selected last.
Basic Dokumentation RVA63.280, RVA53.280
All outputs are switched according to normal control
operation
All outputs are deactivated
Burner stage 1 (K4) is activated
Burner stages 1 and 2 (K4 + K5) are activated
D.h.w. charging pump / diverting valve (Q3 / Y3) is
activated
Heating circuit 1 / boiler pump (Q2) is activated
Mixing valve HC1 OPEN (Y1) is activated
Mixing valve HC1 CLOSED (Y2) is activated
Heating circuit pump HC2 (Q6) is activated
Mixing valve HC2 OPEN (Y5) is activated
Mixing valve HC2 CLOSED (Y6) is activated
Line
17/184
CE1P2374E
19.04.2001