Siemens RVA63.280 Basic Documentation page 13

2. Check
3. Fitting
4. Fixing
Siemens Building Technologies
Landis & Staefa Division
• Check to ensure the fixing levers are
turned inward
• Check to make certain there is
sufficient space between the front
panel and the fixing levers
• Slide the controller into the panel cut-
out without applying any force
è
Note:
Do not use any tools when inserting
the unit into the cut-out. If it does not
fit, check the size of the cut-out and
the position of the fixing levers.
Tighten the 2 screws on the front of the
controller
è
Note:
Tighten the screws only slightly,
applying a torque of maximum
20 Ncm.
When tightening the screws, the
fixing levers automatically assume
their correct positions.
Basic Dokumentation RVA63.280, RVA53.280
13/184
CE1P2374E
19.04.2001