Fspf Dead-Interval - HP 6127XLG Blade Series Command Reference Manual

Parameters
value: Specifies the FSPF cost in the range of 1 to 65535.
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
Each link has a cost. The route selection algorithm uses this value to determine the best route. The smaller
the interface FSPF cost, the smaller the link cost.
Examples
# Set the FSPF cost to 1000 for interface VFC 1 in VSAN 4.
<Sysname> system-view
[Sysname] interface vfc 1
[Sysname-Vfc1] fspf cost 1000 vsan 4

fspf dead-interval

Use fspf dead-interval to set the dead interval for an interface in a VSAN.
Use undo fspf dead-interval to restore the default.
Syntax
fspf dead-interval value vsan vsan-id
undo fspf dead-interval vsan vsan-id
Default
The dead interval is 80 seconds.
Views
VFC interface view
Predefined user roles
network-admin
Parameters
value: Specifies the dead interval in the range of 2 to 65535 seconds.
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
After two switches establish a neighbor relationship, they send hello packets at the hello interval to each
other to maintain the neighbor relationship. The dead interval specifies the interval during which at least
one hello packet must be received from a neighbor before the neighbor is considered to be nonexistent
and is removed.
The dead interval must be greater than the hello interval and must be the same at the two ends of the link.
Examples
# Set the dead interval to 100 seconds for interface VFC 1 in VSAN 4.
<Sysname> system-view
[Sysname] interface vfc 1
64