Npv Auto-Load-Balance-Interval - HP 6127XLG Blade Series Command Reference Manual

Use undo npv auto-load-balance enable to disable automatic load balancing in a VSAN.
Syntax
npv auto-load-balance enable
undo npv auto-load-balance enable
Default
Automatic load balancing is disabled.
Views
VSAN view
Predefined user roles
network-admin
Usage guidelines
Only NPV switches and VSANs operating in NPV mode support this command.
The automatic load-balancing process is as follows:
1. The system starts a delay timer when it detects a new operational uplink interface.
2. The system automatically redistributes downlink interfaces across all uplink interfaces when the
timer expires.
If another uplink interface becomes operational before the timer expires, the system resets the
timer.
The automatic load balancing feature might trigger a load balancing process when a new uplink
interface becomes operational, which causes traffic disruption. When this feature is disabled,
downlink-to-uplink interface mappings are not affected.
Examples
# Enable automatic load balancing in VSAN 1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] npv auto-load-balance enable

npv auto-load-balance-interval

Use npv auto-load-balance-interval to set the delay timer for automatic load balancing in a VSAN.
Use undo npv auto-load-balance-interval to restore the default.
Syntax
npv auto-load-balance-interval interval
undo npv auto-load-balance-interval
Default
The delay timer is 30 seconds.
Views
VSAN view
106