6. Troubleshooting
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Target Part/SP No.: Duplex Exit Sensor / SP5-803-010
Execute an INPUT check when there is no paper at the position of the
referenced sensor.
Execute an INPUT check when there is paper at the position of the
referenced sensor.
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Jam
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem
Judgement" column, follow the solutions.
Bypass No Feeding: Cause Code 008
Target Part/SP No.:Bypass/Duplex motor / SP5-804-071 (Duplex Bypass Motor: CW:
Standard Speed)
Turn the referenced motor OFF with OUTPUT
Turn the referenced motor ON with OUTPUT
Solution:
• Reconnect the connector.
• Replace the motor.
1012
Cause verification
Cause verification
Problem Judgement
0: Paper detected
1: Paper not detected
Problem Judgement
Drive sound heard
Drive sound not heard