Paper Exit Sensor: Lag Jam: Cause Code 060 - Ricoh MP C2504 Field Service Manual

• Replace the motor.
• Replace the Paper Transport IOB.
• Replace the harness.
Checking paper jam, or paper status
Check if there is no double feeding.

Paper Exit Sensor: Lag Jam: Cause Code 060

Target Part/SP No.: Paper Exit Sensor / SP5-803-008
Cause verification
Execute an INPUT check when there is no paper at the
position of the referenced sensor.
Execute an INPUT check when there is paper at the position
of the referenced sensor.
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Checking paper jam, or paper status
Check if the leading edge of the paper and the paper feed
guide are wet.
Check if there is no double feeding.
Check if the paper is curled too much.
Check if extra thin paper or thick paper exceeding the
supported paper thickness is being used.
Troubleshooting for Transport/Paper Feeding of the Machine
Fan the paper.
Problem Judgement
0 :Paper detected
1: Paper not detected
If condensation has occurred inside
the machine, leave the machine idle
for a few minutes to remove
condensation.
Fan the paper.
If the paper is curled too much, switch
on the anti-condensation heater for
paper tray.
Use a supported paper type.
1025