Table of Contents
Advertisement
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 3 "Parts listing" on page 29 to determine which components are consumable, structural, or CRU
parts.
• If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code
Event ID
0x806f0207
806f0207-2584ffff
Type
Error Message
Error
Group 4,
processor X (All
CPUs) BIST failure
[Note: X=1,2]
Action
system-board
assembly" on page
71).
1. Remove the blade
server and ensure the
processors are
installed correctly
(see "Installing a
microprocessor and
heat sink" on page
65).
2. Verify that the system
is running the latest
UEFI firmware (see
"Updating firmware
and device drivers"
on page 23).
3. Run the Setup utility
(see "Using the Setup
utility" on page 11).
a. Make sure that
both processors
are displayed by
the system.
b. Load the default
settings.
c. Go to the System
Settings menu
and make sure the
processor is
enabled.
4. Clear the CMOS data
by removing the
system battery for 30
seconds (see
"Removing the
battery" on page 41
and "Installing the
battery" on page 42).
5. If the problem
continues, replace the
processor (see
"Removing a
microprocessor and
heat sink" on page 61
and "Installing a
microprocessor and
.
153
Chapter 5
Diagnostics
Advertisement
Table of Contents
