Installation Of The Control Unit - Mitsubishi MELDAS MDS-C1 Instruction Manual

1-3 Installation of the control unit

CAUTION
1-3-1 Environmental conditions
Environment
Ambient temperature
Ambient humidity
Storage temperature
Storage humidity
Atmosphere
Altitude
Vibration
1. Installation
1. Install the unit on noncombustible material. Direct installation on
combustible material or near combustible materials may lead to fires.
2. Follow the instructions in this manual and install the unit while allowing for
the unit weight.
3. Do not get on top of the units or motor, or place heavy objects on the unit.
Failure to observe this could lead to injuries.
4. Always use the unit within the designated environment conditions.
5. Do not let conductive objects such as screws or metal chips, etc., or
combustible materials such as oil enter the units.
6. Do not block the units intake and outtake ports. Doing so could lead to
failure.
7. The units and servomotor are precision devices, so do not drop them or apply
strong impacts to them.
8. Do not install or run units or servomotor that is damaged or missing parts.
9. When storing for a long time, please contact your dealer.
10. Always observe the installation directions. Failure to observe this could lead to
faults.
11. Secure the specified distance between the units and panel, or between the
units and other devices. Failure to observe this could lead to faults.
0°C to +55°C
90% RH or less
–15°C to +70°C
90% RH or less
Indoors (Where unit is not subject to direct sunlight)
With no corrosive gas, inflammable gas, oil mist, dust or
conductive fine particles
Operation/storage: 1000m or less above sea level
Transportation: 10000m or less above sea level
Operation: 4.9m/s
Storage/transportation: 49m/s
Conditions
(with no freezing)
(with no dew condensation)
(with no freezing)
(with no dew condensation)
2
(0.5G) or less
2
(5G) or less
1 - 9