Mitsubishi MELDAS MDS-C1 Instruction Manual page 55

(3-1) Connection for full-closed synchronous control
(when using MDS-C1-V1 drive unit and serial output linear scale)
Linear scale
MDS-C1-V1
(Slave axis)
CN2
Parameter settings
No. Abbrev. Parameter name
SV025 MTYP Motor/detector type
(Note) The full-closed system using two MDS-C1-V1 units is not compatible with current command synchronous control.
2. Wiring and Connection
MDS-C1-V1
(Master axis)
CN3 CN2
Set the detector type. (Refer to Chapter 3 Setup for details)
Speed command synchronous control : D0xx or D1xx or D2xx
Master axis Speed command synchronous control : A0xx or A1xx or A2xx
Slave axis Speed command synchronous control : D0xx or D1xx or D2xx
2 - 22
Master axis
Detector cable
CNV12
MDS-B-SD
Signal distribution unit
CN3
Description
Slave axis
CN3
CN3A
CN3B