Mitsubishi MELDAS MDS-C1 Instruction Manual page 57

(3-3) Connection for full-closed synchronous control
(when using MDS-C1-V1 drive unit and MP scale)
MP scale
MDS-C1-V1
(Slave axis)
CN2
Parameter settings
No. Abbrev. Parameter name
SV025 MTYP Motor/detector type
(Note 1) The MP scale (high-speed serial interface) is compatible only for the high-gain mode.
(Note 2) The full-closed system using two MDS-C1-V1 units is not compatible with current command synchronous control.
2. Wiring and Connection
A/D converter
MDS-C1-V1
(Master axis)
CN3 CN2
Set the detector type. (Refer to Chapter 3 Setup for details)
Master axis Speed command synchronous control : A1xx or A2xx
Slave axis Speed command synchronous control : E1xx or E2xx
2 - 24
Master axis
Detector cable
CNV12
MDS-B-SD
Signal distribution unit
CN2
CN2A
CN2B
CN3
Description
Slave axis
CN3
CN3A
CN3B