Table of Contents
Advertisement
4. Install two M5 U-type Tinnerman clips for each of the front columns of the
Figure 13: Installing the Tinnerman clips
5. Assemble the outer rails by completing the following steps:
Core Switch 2/64 V4.1 Installation Guide
rack in the top and bottom positions of the three-hole pattern as shown in
Figure
13.
a. As an aid in assembly, two rubber washers have been included to help
keep the rear slotted portion of the outer rail flush against the rear rail-tray
brackets. Install them as shown in
Installing and Configuring the Core Switch 2/64
Figure
14.
63
Advertisement
Table of Contents
