Table of Contents
Advertisement
Figure 34: Aligning the CP card
7. Verify that the power LED on the CP card shows a steady green light (it may
Note:
tests.
Core Switch 2/64 V4.1 Installation Guide
Do not force the card or filler panel in the slot. If the 16-port card or
Caution:
filler panel does not slide in easily, adjust the alignment with the rail guides
accordingly.
require a few seconds to turn on). If it does not turn on, check that the CP card
is firmly seated.
The LED patterns may temporarily change during POST and other diagnostic
d. Refer to the section
Connection, on page 76 in
required to the CP card, as follows:
— Modem cable to the modem serial port
Setting Network Addresses via a Network
Chapter 2
for correct values. Connect cables as
Installing Core Switch 2/64 FRUs
SHR-252
141
Advertisement
Table of Contents
